Hello! I want to read the status and alarms from YLP series IPL laser. Laser starting, but after 1 to about 20 seconds switch off laser beam. After reset( switch off power and switch on) starting again. How read data from YLP via rs232?
Hello! I want to read the status and alarms from YLP series IPL laser. Laser starting, but after 1 to about 20 seconds switch off laser beam. After reset( switch off power and switch on) starting again. How read data from YLP via rs232?
Last edited by Automatos; 09-30-2013 at 00:50.
... I have an YLPM-16-TP - here it's a special data packet format with data-load count and checksum used for the communication (pushing and/or polling) with the laser :-/
Viktor
Hello!
I was able to connect with the YLP with commands from http://sparkycnc.com/pdfs/YLP-HP.pdf and laser cerrectly reply.
On page 23 of this pdf is return value interpretation for command $11. unfortunatly bit nr 15 is "reserved"-somebody know what is this warning?
regards Krzysiek
Hello, i bought fiber laser source 20 w , YLPM-16-TP
How can i start work? What i need?
May this help
http://users.skynet.be/m28/eBay/User...e_E9944592.pdf