-
internal electrical voltage IPG YLP-1-100-20-20
Hello, I am new and I hope I am in the right forum on the right place ! :-) Sorry for my bad english!
I have an 20W fiber laser (YLP-1-100-20-20 with rofin controller )with the following behaviour:
- stopped working from one moment to the other
- no laser emission, red pilot laser works, so fiber seems to be ok
- no power consumption if I increase laser power (about 500mA consumption, should be about 7 A at full laser power)
- cant communicate with RS232 ( got signal on TD (RS232) but no answere)
My Questions:
- Has anybody the notice of the internal voltages between pin 19, 20 and 14? I measured 19 to 20 about 14 volts, 20 and 14 about 3.15 Volts?
- Has anybody had the same problems and solved it?
Best regards to all, holle
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules