I was given three older Big Dipper lasers when I purchased some moving lights from a club that has closed. I gutted them, since all I wanted was the case.
Here is what I have:
Five sets of scanners - these are presumably all 20k. They all wiggled when I sent them an ILDA signal. Beyond that, they may need a tune up. Two of the five sets were in a separate box and said "new" - one of the new sets has a broken off mirror. There is no replacement mirror.
One Fenix Technology ILDA card. It's complete as shown - ILDA in and out, along with the address DIP and cable. No other cables are included. It made the galvos move and the diodes turned on when the laser was powered, so I presume it works fine for ILDA control.
Two Reflect Red, pass green mirrors.
Three reflect blue pass green and red mirrors.
One Big Dipper B10000 control card. Maybe it works, maybe it doesn't. It's included anyway!
One Green 532nm 100mW diode. It's dim, or dirty inside.
Two Red 650nm 400mW diodes. One is possibly just dirty/unaligned, and the other was dim.
Three Blue 450nm 500mW diodes. They turned on, but are a little cloudy around the beam. Could use a cleaning, alignment, tune up, whatever.
One Violet 405nm 200mW diode. It turns on. It's dark purple/UV - no idea what it came from, it was in the box of new scanners.
$135 which includes flat-rate shipping (to the US only, sorry my Canadian friends)- I figure the working scanners and a good ILDA card are worth that. I'd rather not throw everything into a dumpster, but I can!
First buyer takes all. I'm not going to do any extensive testing to check any of the stuff out - it all turned on (lasers were only tested for 2-3 mins to see what worked). The dim diodes may needed to warm up. Maybe they're all old. No idea.