Laser Projector Enclosure with 6800 Scanset

[Junktronix]

This is a varianced Mobolaser projector housing with a working Cambridge 6800 scanset. Lots of room to add your laser(s). The warning label says Class 4 argon ion, but I can't see how they would have fit something like that inside. It uses a big round AMP connector for signals and comes with a long cable with a DB25 on the far end labeled to QM32. I'm not sure if QM32 predates the ILDA standard so it might need to be rewired. It wouldn't be difficult to just add a DB25 to the back panel instead. Asking $600 plus shipping.

[dsli_jon]

Wow, seen a Lot of 'Mobo' skak over the years, but never seen That one.. Wonder if it was a 'one off' / prototype-dealeo.. Too bad there aren't 2x available (SL/SR, and all..) Interesting, tho..

...I'm not sure if QM32 predates the ILDA standard so it might need to be rewired. ...

..Or, for those less-inclined, the QM-32 pinouts are here http://pangolin.com/QM32_pinouts.html ..and even better / simpler, just hit Pango up for an 'adapter cable' (for yer adapter cable.. http://pangolin.com/LD2000/qm2000pinouts.htm ..See Column on the left for that cable-info / 'Caution'.. They prolly have a few laying around, and if not, I'm sure a few 'old-timers' in PL, here, likely have one / two they'd part with (we do..) in old Pango QM-boxes, etc..

Fwiw..
j

[Vidal Wolf]

Thats a Lowell Products Design, laser projector. I did a few shows with them and the bastards never paid me.
I recognize the stickers.
They made Lil G and G beam knockoffs. Pretty good ones I might add.

[Junktronix]

Bastards! This might have been a one-off for Newaje...

[kecked]

Add a dtr diode pack and you have a nice projector for cheap.