Activity Stream

Pulsed high current DC to the diodes, I don't have a power supply capable of doing so but for now, want to use them at a constant current with a AOM or something to produce short bursts, high peak power out of the ND:YAG to produce more efficient SHG conversion to green. I was wrong about the IR...

... sounds reasonable :cool: On the other side - when only shortly activated (and with massive cooling), diodes can be "overpowered" with up to 50% for some millisconds and up to several 100% for microseconds ... then they'll need some seconds for cooling down. So for "pulsing" applications...

The donut diode rings are each 100 watts, I believe this is likely DC watts into the diodes, three 100 watt rings producing 300 watts at 50% efficiency would be 150 watts of IR pump power, so it stands to reason the output of the ND:YAG is 1/3, or 50 watts, perhaps 60. Is my reasoning valid?

... for typical power-efficiency with diode pumped lasers, here some numbers: Sometimes around 2005 I had a "disk"-laser with 20Watts averaged, which was pumped with a 60Watt IR-laserdiode-module. Modern fiberlasers too needs around 3x the later "averaged" output power as combined...

Ah, 120+ with flash lamp. Best I've come to find for the ND:YAG output of the diode pump driven 300W Avia Thor head is about 40 watts for a single head, but when searching online for typical output percentage of the pumped power for 1064 nm output, estimates are much higher. Appears I have a bad...