PDA

View Full Version : FB3 SE with DMX control



FireOneMalta
06-17-2011, 02:08
I need some guidance on how to start a laser show that is downloaded inside an FB3-SE with a dmx daughterboard attached by sending a dmx pulse from my Enttec USB Pro device.

I cannot figure out how to do such an operation and what settings should i use.

Once that the display is trigerred it will proceed on its own, thus I am interested in only starting the show.

Any guidance will be highly appreciated.

Thanks

Nick

smokeAndMirrors
06-17-2011, 08:14
<deleted as I misunderstood your post>

cyberb0b
06-18-2011, 03:15
Why don't you contact Pangolin directly?

I think they are the best source of info for your specific question.

Stuka
06-18-2011, 05:42
I also have a FB3 SE with the DMX board.

The DMX functionality of the daughterboard is basically designed to let you select, display and manipulate the frames that you would load to the onboard memory via the LiveQUICK software.

If you want to run full shows, you really need to use QuickSHOW, since you can assign a show to a cue, then select the cue via DMX or MIDI.