PDA

View Full Version : FlexMod p3 interlock



fcanducci
03-16-2015, 07:05
Good Morning
I purchased the card FlexMod p3 (interlock monitor output).
Now I was trying to do the setup, but I always have the red LED on and no output, can not figure out how to maintain closed interlock.
Can anyone help me

thanks 1000

Google translate

Datsurb
03-17-2015, 08:02
The manual can be downloaded here:
https://innolasers.com/shop/index.php?id_product=11&controller=product

It says: Iterlock must be connected to V+.

This thread gives you a good idea of what and how.
http://laserpointerforums.com/f51/how-set-up-flexmod-p3-handheld-laser-56572.html

dummie
03-30-2015, 15:09
Everything's already properly set up. The interlock light is pulsing on/off for a few times before it stays on.

dummie
03-30-2015, 15:11
Everything's already properly set up, as can seen from the pictures. The interlock light is pulsing on/off for a few times before it stays on.

dummie
03-30-2015, 15:12
Everything's already properly set up, as can seen from the pictures. The interlock light is pulsing on/off for a few times before it stays on.
Also, my setup is different because of the modulation from arduino.

dummie
03-30-2015, 22:20
I'm unsure what happened on this thread, could a kind mod remove my triple post?