Connecting the 445nm

Hello Peeps.

How about a detailed instruction for us with not so electric fingers.
I for one has burned to many 405´s to feel safe connecting these new 445 to a FlexmodV2 directly.

I have bought some lasorbs, and think i have a good idea on how to connect it all.
But then i just saw this post.
http://www.photonlexicon.com/forums/...ad.php?t=11471

is that resistor only becouse of the red? or should there be a resistor there for the 445?

please someone with the propper knowledge explain or make a simple drawing here how these new 445 diodes should be connected.

flexmod -> lasorb? ->resistor? -> diode?

thank yuo.
/Rick

The way I would do it if I were using a lasorb is to connect the lasorb directly to the diode pins, or as physically close to the diode as possible (perhaps shrink-wrapping it in-line from the Flexmod output if there's not enough room to attach it to the diode pins), then connect the ends of the Flexmod output wire to the diode. I haven't ever used a lasorb though, so after verifying that the Flexmod's currents are set properly I just connect the diode directly to the Flexmod.

300evil clued me in about soldering header pins on the flexmods. i took things a little farther and used laser diode sockets from thorlabs so i didn't have to solder directly to the diode.

it works like a champ to solder lasorb and wires to one side of the socket and plug the diode in the other.

http://www.thorlabs.us/NewGroupPage9...=302&pn=S7060R

here's a few thousand words..

Attachment 17724Attachment 17730Attachment 17726Attachment 17727Attachment 17728Attachment 17729Attachment 17731Attachment 17733Attachment 17732

(observing usual ESD precautions)

I pre solder the Lasorb to a small strip of Vero board, pre solder the feed wires (leaving the free ends shorted until driver connection.

Then I epoxy the board into position, when the epoxy has cured I solder the diode pins (a good hot iron is best, minimises heat duration).

http://www.photonlexicon.com/forums/...chmentid=17736

I'm so glad you posted that pic Doc, your description of that setup previously was what prompted me to post my other thread last night. Just couldn't quite work out what you meant. So you junk the rear section of Aixiz housing then?

Hey C...

Quote:

---

Originally Posted by swamidog

...i took things a little farther and used laser diode sockets from thorlabs so i didn't have to solder directly to the diode.

---

Nice! Good-call :cool:... and I was 'intrigued' by the "SR9HB - ESD Protection and Strain Relief, Pin Style B, 7.5 V" - especially the "Customer Inspired" -part... ya think: 'Lasorb-Inside'?? :confused:
(or, maybe, 'Lasorbish-clone'??) that'd be really nice.. might be worth a call to the Thor-hotline.. :cool: ....but $45. ouch....

Then, again, last month, this much blue was $multi-K, so, I'll prolly just shuddup, now, about 45-measily-bux right?? http://www.photonlexicon.com/forums/...ons/icon10.gif ...especially if they do-prove to have an 'imbedded' Lasorb... truly, 'plug-n-play'... :cool:

..thanks for sharing... http://www.photonlexicon.com/forums/...ons/icon14.gif
peace...
j

Quote:

---

Originally Posted by norty303

So you junk the rear section of Aixiz housing then?

---

Yes, the epoxied vero board serves as enough strain relief.