would this driver work?

just found this:
http://www.roithner-laser.com/datash.../EU-38-TTL.pdf

would it be ok to run with a 1W 445nm?

if not any other driver in here that would be ok?
http://www.roithner-laser.com/ld_drivers.html

It will work, but only ttl (on/off).
And it is doubtful if you will reach 1A.
Supply voltage is 5V, voltage of a 445 diode @ 1A is around 4,5 volt.
That leaves 0,5 volts for the driver, which is probably too low.

So you'll need a driver that has a supply voltage of at least 6 volts, capable of at least 1 Amp, at least 10kHz preferably analogue modulation.

Why not use the die4drive or the flexmod ?
Or do you insist on spending m€ga on a driver?