Stan_Ham diode driver (analog)

This is very good news. Just to be clear, these are single channel, analog modulation, soft start w/ beam suppression?

If so, I would be interested in 6 bare boards.

Thanks.

Yes thats right.

Rob

Any news on this driver kit ? :)

Just a question

I want to replace the transistor in the original diagram with a mosfet any suggestions?

Thanks and cheers,
Ed

anyone ever update the schematic?

I can make the PCBs myself without issue

well I gave up waiting, if anyone want's boards I got some made, have extras so I am offering them up at cost ($2) plus actual shipping if anyone wants any

http://flecom.net/fs/IMG_20150427_231909.jpg

as you can see I totally screwed up the silk screen layer but it should be ok otherwise

I'll take 10 if you have that many left over.

Thanks,
Eric

I'm going to build one tomorrow to test it and make 100% sure I didn't mess it up...

I have about 80 boards, I sent some boards to manufacture overseas for another project and sent these along since most of the cost is shipping anyway

Quote:

---

Originally Posted by flecom

I'm going to build one tomorrow to test it and make 100% sure I didn't mess it up...

I have about 80 boards, I sent some boards to manufacture overseas for another project and sent these along since most of the cost is shipping anyway

---

I'm interested in a bunch of these to run some 2W 445nm diodes I have on the way. I haven't gone through all ten pages of this topic but is there a place I can download the latest schematic (the one these boards are based on)?
I was going to purchase some Flexmod P3s from Innolasers but I'm guessing these drivers will do everything I need to analog modulate my 445s and at far less cost than the P3s.

@flecom, i will take 2 please :)