Printable View
Yes,have some improve.not much.:)Quote:
Originally Posted by Jem
Current DT40pro scanner of hard-core very perfection, just need improve some specific.
1.change the plug and play fuse.when you making a show,don't need any tool to replace it ,if the fuse break;)
2.Replace a new powersupply for DT40pro,even same +/-24V 1A.
But the quality better more(also the cost higher more).
Just the cubage larger,but I think never mind,we need a stabilization and good quality product:)
PS.
Just make order the new powersupply,after 3 weeks complete use new powerspply for DT40pro.
3.For 5mm beam of mirror.Before
（X）7X9X0.8mm （Y）7X12X0.8mm
Now X=Y same 7X12X0.8mm
Because before the Y mirror longer 3mm than X mirror,even just longer 3mm ,but the Y galvo just 50% eligibility,the X galvo >90%eligibility.
Y galvo have many problems,like speed too low,too much resonance ,noise too high etc..
Now everything all resolve:)
And use 7X12 mirror alway better for build RGB or 5mm beam laser of system.
So use same long mirror for X galvo.
http://www.dtelectronic.cn/Uploadfil...3201548555.jpg
25K lower cost and high quality scannerOptical angle
60 ° max.
ScanSpeed
25K-28Kpps ILDA at 8°
20K-22Kpps ILDA at 8°(For 5mm beam of mirror)
Mirrors type
High quality dielectric mirrors
reflectivity>95% at 400nm-700nm
Mirrors size
3mm beam laser application 5X10X0.8mm
5mm beam laser application 7X12X0.8mm
Signal Input voltage
± 5V
Power requirements:
110V-220V AC Output ± 24V 1A
Warranty
24 months
Currently complete improve from Bill's suggestions .Quote:
Originally Posted by Jem
I have been send one set 5mm beam scanner to Bill.
Still waiting his suggestions,hear he is very busy lately.