The building starts here - RGB DT40 scanner

Might be a tad small depending on how close the scan set is to the aperture. I have an 80mm round window but my galvos are further back. You could get the old protractor out and see where the beams will go.

-Matt

the galvo mirros are 20mm away from the hole

Quote:

---

Originally Posted by andy_con

is my hole (so to speak) to small???

20mm

---

My hole is 2" square and that is about right.

2 inchs!!!!! fook!!!!

i may have to make mine bigger, some how?

2" may be larger than you need. You'll need to do the math. Also, if you ever decide to add a piece of glass to the hole to keep out dust you will need to account for that.

yeah ok, as soon as im up and running i will find out i suppose

http://i80.photobucket.com/albums/j1...81143Large.jpg
http://i80.photobucket.com/albums/j1...81144Large.jpg
http://i80.photobucket.com/albums/j1...81145Large.jpg
http://i80.photobucket.com/albums/j1...81146Large.jpg

Lookin good dude. If you're going to use the maximum scan angle of you dt40s, you'd need at least a 30mm square or 43mm diameter round one. Hope its not too much of a bugger to make it bigger.

-Matt

errr i dont know, ill ask the metal place when i take it back haha.

i have an inch by inch block of alum to mount to the back on each item on the bottom level

I know its a little late but nice job-

Andy,

My aperture output window is 4 inches square on my projector. Of course, my galvos are mounted back 2 5/8 inches from the window, so that's part of the reason I needed the large hole. Even so, I can't run my scanners at 100% scan size. If I do, the pattern is larger than the aperture window!

4 inches square was the largest piece of A/R coated glass that OneStopLaserShop had in stock at the time. I figured it would be more than large enough, but I was wrong. (So now I need to re-mount the optical table so it's closer to the front of the case. That will put the scanners closer to the window.)

Adam