anyone with experience please post here.. i have no clue where to start
Printable View
anyone with experience please post here.. i have no clue where to start
Adam dit a nice writeup on scannertunningQuote:
Originally Posted by keeperx
http://lasershowparts.com/files/Arti...20Tutorial.pdf
ok but i have 4 pots an no clue which is which
i think i found it..
http://www.lasershowparts.com/files/...SCANPRO20I.pdf
now im ready to read the PDF and try this
here you goQuote:
Originally Posted by keeperx
http://www.lasershowparts.com/files/...SCANPRO20I.pdf
How messed up are they? Thought that Mark had them tuned up fairly well before you left?
Can you post a picture of the ILDA test pattern, and another one of the LaserMedia Test pattern, both running at 20K and 8 degrees optical or less?
Adam
yeah.. maybe tomorrow..
im sad now i killed a red diode
Wuahaha get used to it....Quote:
Originally Posted by keeperx
I killed alot of the long opencan diodes while testing.
This time of year here with cold air kills the diodes due to static.
In the beginning i killed alot of them trying to find a nice solution to the common ground "problem"
Its best to make the laser, alling it and put it in a nice small enclosure.
Its a sad thing... but thats the price of working with cheap solutions and overpowered diode's
yeah.. but they are cheap to replace
Actually, I didn't mess with the tuning because I wasn't real familiarQuote:
Originally Posted by buffo
with those amps. The tuning wasn't the best on them but, not too far
off with a little tweaking.
Mark
ok i went down the stairs and back up and here is where i am..
Either servo gain is set to low or you're scanning too fast. Also, you need to adjust blanking delay.