Increase output power proector CLP-1000 RGB LASERSYSTEM

[Alex_kld]

Hallo!
i have laser proector CLP-1000 and install laser modul SL series (900 mW, 532 nm)

http://www.rgblasersystem.com/index....id=10&Itemid=2

I want increase output power and instal one more laser modul in special provided position, but can't seach cheap analog of original modul with same size's...
In install modul diammetr of beam 3,5 mm and divergence(full) 0,8 mrad.

At installation of the second module its divergence and diameter of beam should be identical?

[bridge]

Hi Alex,
look here to see if any lasers suitful your using or not.if any interesting, can contact our distributor near or in your country asking for more informations, thanks!
www.laser-wave.com
best regards!
Bridge

[Alex_kld]

Hi Alex,
look here to see if any lasers suitful your using or not.if any interesting, can contact our distributor near or in your country asking for more informations, thanks!
www.laser-wave.com
best regards!
Bridge

All green modules(1 and more W) in our site have width more than it is necessary...
Where to find the green module (1W) which width of 60 mm at the basis?

[carlos3621]

have the manuf. cut the baseplate tabs off, before they anodize, then find ananternative way to mount the laser head