Anyone tried this? I am very interested to see what kind of beam charcter this would yield....I am sure it would be more forgiving about final collimation. May have to install one and see....
Anyone tried this? I am very interested to see what kind of beam charcter this would yield....I am sure it would be more forgiving about final collimation. May have to install one and see....
You are the only one that can make your dreams come true....and the only one that can stop them...A.M. Dietrich
I don't understand why you would do this,
with the quality lenses I use I get a 2,2x1,2mm beam with 0,6/0,7mrad. why would you try to improve this?
I wouldn't think it would be necessary with single-mode diodes.. I also get very good results with quality lenses. If you think about it, a singlemode diode in a simple collimator has a built-in beam expander. Since the light is emitted from a point source with an exceedingly tiny initial beam diameter, it has very high uncorrected divergence. This high divergence means the beam diameter is expanded many times before the light reaches the first lens. I attribute this as the reason singlemode diodes collimate to <1mrad with the simplest lens setup.
A question came to my mind when I read this idea. Does the FAC lens primary correct the different divergence between the two axes or more the astigmatism in a multimode laser? I would assume the second. Since the astigmatism in a singlemode diode is quite small a FAC lens wouldn't make too much sense, when my guess is right. Anyone knows?
I believe you're correct in your assumption. Both types of diodes could benefit from fast axis correction since all diodes suffer from astigmatism, but with multimode diodes the astigmatism is far greater. The divergence angles are thus higher, making FAC necessary for many applications. Also, singlemode diodes naturally collimate so well there's little need for FAC.
The purpose of this experiment is to get at the smallest pincil thin beam possible. A reduction of the fast axis at this level will yield a much smaller beam and the second lens being a smaller focal length and footprint overall. Thinking smaller beam, easier to collimate a few of them into a good beam size. Even the strip shadow should almost go away if the math in my software is correct. Time will tell if we ever get the GB diodes....
You are the only one that can make your dreams come true....and the only one that can stop them...A.M. Dietrich
Hmm interesting, but how will you ever get the FAC in that laserdiode? I think you need a microscope and lab tools.
Is the laserchip mounted close enough to the front that it could just be mounted there to the tip of the diode?
Last edited by MisterWilling; 02-03-2010 at 15:10. Reason: cant spell or type
well if you could find some 1mm diameter glass cylinders, the distance from the chip could be compensated, no?
I have a limited stock of BBAR coated FAC material. I will attempt to mount one and post results as soon as the diodes from the GB arrive. I have installed one onto a C mount 635nm diode and works great in cleaning up the beam. Cylinder lenses are big with me....but open to all options when looking for a new result. Most common material size is 1um. I have some stock that is NOS Melles for the fiber launch on the big greens.....works with the Coherent 20 watters and up....will destoy large Yags in an end pumping arena if not properly adjusted from the onset.....
You are the only one that can make your dreams come true....and the only one that can stop them...A.M. Dietrich