Info wanted on PCAOM Driver II

[satje]

Hello group!

I have a PCAOM II driver build by Laser Animations GmBh from Germany.
On this unit there's a input for a sensor, now i don't have that sensor...

Anyone knows wich kind of sensor can be used on this system?

Ferry

[mixedgas]

Take a pic of the inside, would you? Then we can tell you if its core is NEOS, AA, OR CT...

Steve

[satje]

Take a pic of the inside, would you? Then we can tell you if its core is NEOS, AA, OR CT...

Steve

I can make a Pic later, but it is selectable.... A.A or NEOS

See the attached pdf

Ferry

[FourDee]

May be a PD input for light feedback?

[mixedgas]

May be a PD input for light feedback?

You should not need a PD for normal operation, I think it is for peaking,linearization, and scan safety.
Saw that thing or one very much like it, at a trade show once, was quoted around 7K$ for it...

Steve

[satje]

Yes, it is used for scanning thru the wavelengths and beam optimalisation.

[Dr Laser]

I know a lot about those PCAOMS. It's based on AA. I had 2 full units with drivers and crystals. Sold them both.

[satje]

I know a lot about those PCAOMS. It's based on AA. I had 2 full units with drivers and crystals. Sold them both.

So do you actualy know what kind of sensor is used?
Would be nice if i can obtain one and get automated tuning

Ferry

[TL]

I also have one of these drivers and I asked sollinger (laseranimation) also about the sensor input and got the reply there's no support any more for this unit...