The scanfail fried your scanners?
Senior Member
The scanfail fried your scanners?
Junior Member
Edison, it was nice to see everything,
thanks to you, MCcarrot, and SRS
bad for you about the blue etc etcand of course the green!
but i like the case very very much!very nice
I see you soon again, i think about 3 weeks
Senior Member
Synce, the scanfail stil works so no default there. I have one scanneramp and my whole projector works fine also the safety,s so we are getting there. And if i can,t get it repaired then i buy a pair of DTwidemoves
Realy don,t have a clue what the problem is.
Senior Member
Originally Posted by edison
yes to see green and blue . I have my projector ready so maybe some beamshots if everything goes as it should be.
Too bad it didn't go as it should be....
But the 457nm color is realy REALY REALY beautiful, I'm even thinking of swapping my old school 473nm for a 457nm.... no beter safe it for a new bigger RGB
(2011) first finish my twin greens...
Johan, If you come over to my place we check out the driver, I still have 2 galvo sets lying around so we can compare and see where the problem is.
Senior Member
Probably a ground loop or a wrong connection of the feedback signal.
I can imagine if you connect the feedback signal to ground the driver can go crazy and burn the galvo coil.
Senior Member
I,m probably sooner there when you think. I,m real curieus what the problem is. I will compare the x with the still working y driver to have some more info. Still in need of a galvo tho.
Senior Member
That's what I was wondering.
Well at least look on the bright side Edison, you can get a set of DT-40 Wide! I really want a set of those but, I can't justify spending the money on them (yet) when my DT-30's work just fine. Maybe one day!
Senior Member
As promised i picked up the struth profiles today below the picture:
Senior Member
I'm drooling!
Senior Member
My internals arrive end of this week or beginning of next. I can't wait for the case to put them in!
Posting Permissions
Reply With Quote