Groupbuy?

[edison]

Mccarrot, customers!!!!! Damn i could have asked Mccarrot and ad 3 euro and sell it to you.
But luckily i,m not like that.

[Synce]

Mccarrot customers!!!!!

I'm interested in it too!

[blowfly]

Bummer about the laser cutting machine being broken. Not a big deal though, thanks for the update.

By the way those levers look cool. I missed your post about them before when I was on vacation. I'm happy to pay for it. Let me know how much it costs.

Mike

[edison]

Hello Mike

You don,t have to pay for it , you will get them for free if you willing to do me a favour.

Here is the link how you get them for free.

http://www.photonlexicon.com/forums/...light=groupbuy

[blowfly]

I don't mind doing a little drilling. No problem at all. thanks!!!

[mccarrot]

The new board will also have differential input for the colors, so chaining projectors will not cause power losses, and off course a interlock circuit.

[edison]

I made a small board to make it easy to wire your projector. But mccarrot suggested to ad the safety features on the board so that your 5v to your driver is cut in case of an emergency. However i would like to keep it easy to wire the mains to your PSU,s so he designed a small board with an Solidstate relais to cut the mainpowers to your PSU,s and still keep the benefit of easy wiring. It,s the best of both worlds so
when the board is ready it should be a piece of cake to wire and build a projector. If you choose for quality parts and a good case you save heaps of money and still have a profesional projector.

Al the support to get you guys that profesional laser has benefits for everyone. To have a inputboard with all the safety features in combination with the ILDAloop board from SRS will give you the benefit that all the signal wires goes to one point and also the ground for that matter. Mccarrot can sell these boards to help you save time to wire your projector, and also to make a little bit of money to fund new ideas and his hobby. And when your projector is proper wired that will improve the quality of your projector regardless of what lasers you use. So all in all the best way for everyone

[LEDpaint]

As you see there is a new addition to the case. It,s a lever to clamp the projector under a angle in a bracket. Everyone can have them for free only if you want me to help me out. I use aluminium L shaped strips to mount
the lid and bottomplate. I will cut the aluminium to the right length but if you guys willing to drill the holes for the lid your self in the L-shaped aluminium then you will get 2 of those levers with these case. I will pay for those levers. I think they are a lot better then the simple black knobs.

Can everyone respond to this new feature?

Sure, I can drill holes. They're not always round, but I can do it.

[Synce]

Sure, I can drill holes. They're not always round, but I can do it.

Ehh, "round" is a relative statement.

[satje]

Finaly ordered 3 Traco PSU's...
Also my Raytrack CT driver has arrived yesterday.

Next week or so i will be at Mccarrot's to pick up the dichros and mounts (and maybe a cup of coffee :P)

Going the good way...

Ferry