hi!
Iīve got a Contec Laser engraving system, without schemes or documentation.
2 x 20 W 797nm
leistung.jpg
I think itīs working in this way:
vio_graphic_1.jpg
PC control system:
netzteil-mit-pc.jpg
Power supply and housing of the pumping diodes:
netzteil-6.jpg
inside:
netzteil-1.jpg
netzteil-3.jpg
the diodes on a cooling block:
netzteil-5.jpg
the PC runs on MS-DOS!
pc-1.jpg
Now I have a problem. The power supply is starting with different self tests.
Then it shows:
netzteil-9.jpg
the program says:
emission: no
diode current: ---
diode temperature: ok
I have checked the fuses, the wirings and connectors, but the diodes donīt want to power up.
There is no voltage at the diodes from the power suppply.
I donīt know if it is a problem of the PC control, the power supply or the laser head.
Do you have any idea what I could try?
pc-4.jpg




Reply With Quote
