Results 1 to 5 of 5

Thread: Broken HeNe Tube?

  1. #1
    Join Date
    Aug 2007
    Posts
    55

    Default Broken HeNe Tube?

    Hi guys,

    I recently purchased a 14-inch HeNe tube which arrived in the mail today. I do not have a proper power supply for it so I placed it next to a plasma lamp to check the gas fill. Unfortunately the gas seems to be outside of the capillary bore. I have little knowledge about gas lasers, but it it seems to me that this tube is shot.

    Can anyone please confirm?

    Thanks,

    Kyle
    Attached Images Attached Images

  2. #2
    mixedgas's Avatar
    mixedgas is offline Creaky Old Award Winning Bastard Technologist
    Infinitus Excellentia Ion Laser Dominatus
    Join Date
    May 2007
    Location
    A lab with some dripping water on the floor.
    Posts
    10,114

    Default

    Now it would NOT be fun if the bore was NOT connected to the spare gas and the cathode. Your just fine..
    Anode is at one end, cathode is in the outer bell.. Its done that way to force the discharge down the bore.

    I'm the resident gas laser guy...

    Welcome to PL.

    Steve
    Qui habet Christos, habet Vitam!
    I should have rented the space under my name for advertising.
    When I still could have...

  3. #3
    Join Date
    Aug 2007
    Posts
    55

    Default

    Hi Steve,

    Thank you so much for the response! I've been lurking this forum for years now and have been astounded by the wealth of knowledge you share with the community. Although I dabble with diode and DPSS lasers this is my first gas tube. Earlier today I had quickly checked Sam's Laser FAQ to find out if this was normal behavior for a HeNe tube and panicked a bit when I read about dead/dying tubes resulting from fractured capillaries.

    A few hours I later I started peeking into the crevices of the cathode bell and noticed that the capillary bore did not seem to extend to the HR mirror. I then realized that my tube might be fine after all.

    Again, thanks for the welcome and please forgive my ignorance. I still have much to learn!

    - Kyle

  4. #4
    mixedgas's Avatar
    mixedgas is offline Creaky Old Award Winning Bastard Technologist
    Infinitus Excellentia Ion Laser Dominatus
    Join Date
    May 2007
    Location
    A lab with some dripping water on the floor.
    Posts
    10,114

    Default

    Kyle typed:

    Again, thanks for the welcome and please forgive my ignorance.

    end quote

    What Ignorance???? That was a good question...

    Steve
    Qui habet Christos, habet Vitam!
    I should have rented the space under my name for advertising.
    When I still could have...

  5. #5
    Join Date
    Aug 2007
    Posts
    55

    Default

    I suppose it wasn't such a bad question, I am new to gas lasers after all. It's just that the answer was a bit obvious after a little closer examination.

    I am a bit weary of trusting fragile glass objects to the USPS and jumped to conclusions. It probably didn't help that I saw this picture while browsing Sam's FAQ:



    Now that I know my tube's okay, I need to find a suitable PSU to get it lasing.

    Thanks again!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •