Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: Modulation issues

  1. #11
    Join Date
    Feb 2008
    Location
    East Sussex, England
    Posts
    5,248

    Default

    Just a long shot but I keep reading things about AiXiz modules needing to be isolated from the baseplate due to running the casing hot/cold/whatever. Could this be a reason for the behaviour?

  2. #12
    Join Date
    Sep 2006
    Location
    Netherlands
    Posts
    1,438

    Default

    My thoughts exactly.
    Definitely some kind of isolation and/or grounding issue, combined with pull-up resistor(s) on the inputs.
    Check this first before adding transistors or buffer amps.

  3. #13
    Join Date
    Jan 2009
    Posts
    1,622

    Default

    I also think you guys are right. If you connect the two wires to a modulation signal and the laser won't lase it usually means there is a short between the two wires which might be caused by the red laser's case being hot and shorting to ground.

  4. #14
    Join Date
    Sep 2007
    Location
    Norway
    Posts
    34

    Default

    You are right guys, it came to my mind too from my previous post when I stated that modulation works "ok" with only one wire connected, so I tried to isolate the red module from the base which worked nicely! Thanks for your input on this

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •