Slotted Enclosure Posts/Rails

[Synce]

Edison, would you mind sharing with us wat you used for the rounded corners ?

I believe the rounded corner extrusions Edison uses are Bosch-Rexroth. Very similar to 80/20.

[mixedgas]

I believe the rounded corner extrusions Edison uses are Bosch-Rexroth. Very similar to 80/20.

Bosch is one of the other 3 or 4 makers besides FAZTEK.

There are only 3 or 4 lines extruding that stuff in the world, they run different dies for different remarketers.

So I learned from one of my new coworkers, who autocadded the dies.

Steve

[flecom]

FAZTEK is out of the rounded 1" stuff :\

looks like really nice stuff, think I found the skeleton for my enclosure

[edison]

Have a look at bosch-rexroth i use that for my case.

[mixedgas]

McMaster carr gets theirs from FAZTEK. It will be slightly different.

www.mcmaster.com

also call Faztek, the web site is not always 100% up to date.



Steve