FOR SALE:
650nm 500mw Laser module with TEC and Fan. TTL modulated. My coherent power meter reads 653mw. I have had this for a few months. It was installed but never put into use.
Price $200.00
Product's Technical Parameters: Manufactured by SNOC Lasers.
● Wavelength: 650±5nm
● Output Power: >500mw
● Beam Mode: Near*TEM00(means the beam is not fully dot)
● Operation Mode: CW
● Cooling Mode: TEC+Fan
● Power Stability: ±3%rms,4hour
● Warm-up Time: 5min
● M2 Factor <20
● Beam Divergence,Full angle: <3 mrad
● Beam Height At Aperature(1/e2* Representative Value): ~6.0mm
● Beam Height From Base*Plate: 55mm
● Spectral Linewidth: <1.5nm
● Polarization Ratio: >50:1
● Pointing Stability After Warm-up: <0.05mrad
●Operating Temperature: 10~35℃
● Expected Lifetime: 10000 hours
● Net Weight: 1.5kg
● Dimension: 80mm*40mm*30mm
● Power Supply(80~260VA): 110-250V
● TTL Modulation: * *
Attachment 27347
635nm 300mw laser module with TEC cooling and TTL Modulation. Another module that was installed but never put into use. My coherent power meter reads 345mw.
PRICE is $275.00
Product's Technical Parameter: Manufactured by SNOC Lasers.
● Model No.: L—635-300
● Wavelength: 635±5nm
● Output Power: >300mw
● Beam Mode: Near*TEM00
● Operation Mode: CW
● Cooling Mode: TEC+Fan
● Power Stability: ±3%rms,4hour
● Warm-up Time: 5min
● M2 Factor <2.0
● Beam Divergence,Full angle: <3 mrad
● Beam Height At Aperature(1/e2* Representative Value): ~6.0mm
● Beam Height From Base*Plate: 55mm
● Spectral Linewidth: <1.5nm
● Polarization Ratio: >50:1
● Pointing Stability After Warm-up: <0.05mrad
●Operating Temperature: 10~35℃
● Expected Lifetime: 10000 hours
● Net Weight: 2.5kg
● Dimension: 152x55x50.2mm
● Power Supply 80-260VAC
● TTL Modulation: 0-30K
*
Attachment 27348Attachment 27349Attachment 27350
Laser Driver and supply with ability to control your TEC cooling on your diode along with a fan output. TTL Modulated. Best using this with 445nm diodes.
Price $40.00
Attachment 27351Attachment 27352Attachment 27353
Shipping will be priced depending on your location and the weight of the item. Payment should be made using Paypal. Send me a
PM and I will provide the details.