Pat's MicroMount Review!! - microlaserlabs.com

[dash8brj]

Hey Pat, you have incoming pm - I need 3 of these to finish the optics train in my pj. Then I can work on actually putting some lasers in it :P

[b52productions]

i would like a few if u still have them

[Laserman532]

I still have some, and will sell them until they are gone, and will not be making any more. PM me if you want some and Ill get back to you.

[Wmacky]

I would image these are all gone now?

[sugeek]

I would image these are all gone now?

Pm and find out I bet there are a few hanging around. I love the ones I have!

Adam

[Laserman532]

they are here, you just need to specify if you want the foot under the mirror or foot under the screws.

http://www.ebay.com/itm/141301724145...84.m1555.l2649

[Wmacky]

Thanks, That's great news. could I get a couple measurements? The height of the foot itself, and the distance from the top of the foot to the bottom of the mirror plate. These would be used in extremely tight quarters! Are you able to shorten either of those distances? My beams are just off the deck!

[Laserman532]

the mount height is 1"
the height to center of mirror is .75"
the foot thickness is .25"
the mirror size of free plate is .5 x .5"

I currently only have reverse foot available (about 10) (foot under screws)

[drm916]

the mount height is 1"
the height to center of mirror is .75"
the foot thickness is .25"
the mirror size of free plate is .5 x .5"

I currently only have reverse foot available (about 10) (foot under screws)

Still available?

[absolom7691]

I think Pat's store might be down. At least, I can't get it to load.