Qui habet Christos, habet Vitam!
I should have rented the space under my name for advertising.
When I still could have...
were should i connect it?
The wiring should be near by, look under the frame.
Steve
Qui habet Christos, habet Vitam!
I should have rented the space under my name for advertising.
When I still could have...
do you know which pin it should be hooked to?
can it be that it should be at ground potential?
Qui habet Christos, habet Vitam!
I should have rented the space under my name for advertising.
When I still could have...
i´ve looked at some picturs on the net,
it looks like it´s connected to the anode!!?
sams laser faq says
Oh and yes, a sizable current is leaked through the tube assembly to the water, preferably from a designed-in ground wire that is installed at the cooling water input on the tube at the cathode end (thin red wire). Otherwise it comes from the anode block, which it will probably rapidly corrode.
so does this mean that i should connect it to the anode?
i´m starting to talk to my self through PL
The wire should be connected to the anode. There should be a thin red wire coming from the anode to somewhere near the cathode. As MG said, it's underneath the frame.
Do make sure the red boot covers the pin completely. The wire (and anything conductive connected to it) is at anode potential.
Last edited by Stoney3K; 06-06-2010 at 11:30.