Senior Member
Lasorb connection conundrum...
Ok, so the datasheet for the Lasorbs says that they should be connected no further than 1cm from the diode.
Well that would require it to be inside the Aixiz housing, but the Lasorb is too big to fit.
So what does everyone else do about mounting their Lasorbs? Do you just mount them as close as reasonably possible?
Any pics to show what you've done?
Senior Member
Originally Posted by 300evil
freakin show off!!!!
Dang those is sexy.
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Ha! Thanks! I wanted to get the lasorb a little closer so it would sit on the base of the modified Axiz module but the smallest soldering tip I had is only so thin.
Now, if I only had the parts to build me a dual blue!
Senior Member
wait a while, i think dr lava will have a dual for about $40.00
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Na, I want a matching set. I'll wait for yours.wait a while, i think dr lava will have a dual for about $40.00
Senior Member
but they still will not fit in the module barrel, correct?
Correct.... although. You may be able to carefully sand off the casing just enough to make them fit.
Senior Member
Acording to Pangolin's product video you just lose protection between the zorb and the diode; if that section is enclosed inside the barrel then there's no problem.
But the barrel is just a codpiece anyway, it just sticks out and gets in the way.
Doc's website
The Health and Safety Act 1971
Recklessly interfering with Darwin’s natural selection process, thereby extending the life cycle of dim-witted ignorami; thus perpetuating and magnifying the danger to us all, by enabling them to breed and walk amongst us, our children and loved ones.
Senior Member
Whats the additional resistor for?
Posting Permissions
Reply With Quote
300EVIL
