Hi guys,
Don't know if there is a post like this but I couldn't find it.
What I like to do is run interlock over the same Ethernetcabel that I use to connect the QM2000.net to my laptop.
The interlock uses 6 lines:
- 2 for keyswitch
- 2 for resetswitch
- 2 for LED
If i'm right ethernet uses only 2 pairs of the 4 pairs. I would like to run over the other 2 pairs the 2 switches. The LED will not be transferred and will be left on my stagebox that i will build.
I will get the next configuration:
Stage FOH
1. Ethernet 1 ------------------ Ethernet 1
2. Ethernet 2 ------------------ Ethernet 2
3. Ethernet 3 ------------------ Ehternet 3
4. Keyswitch ------------------ Keyswitch
5. Keyswitch ------------------ Keyswitch
6. Ehternet 4 ------------------ Ethernet 4
7. Resetswitch ---------------- Resetswitch
8. Resetswitch ---------------- Resetswitch
Can i use this or is tis effecting the working of my laptop/dac or interlock connection? There will be a 100Mbit connection. That will be enough right?
The reason that i want to use this setup because it saves me a lot of cables running from FOH to the lasersetup.
Thanks already for input and/or suggestions!