Hi All,
Since we have had so much luck with the NEW diodes it has been decided to let a few of the 130mW units go... :P
These are new and tested for 2 hours to verify operation ..
They still have TTL modulation but the voltage required to clamp to threshold is a bit higher...about +5.5volts,all this means is this will require an outboard voltage translator..
If you do not need this (blanking) feature..Please disregard..The module will run as normal![]()
Basically a simple ciruit using an opto-isolator using the same power source and a few resistors..Very, very simple..We can provide it ..if needed..
We have ran out of room inside the unit to include it...
It is the same add-on we suggest for all the maXYZmodules products to use with Lasershow software.
We are working on a new driver board that uses Surface Mount components
this will give us the room inside for the extra parts...
This is the true color of the beam...
Each one will be measured and set to at least 130mW output
Get them while you can
The price is:
310.00USD plus 15.00USD shipping in USA/Canada
310.00USD plus 30.00USD shipping outside of USA
If paying by PayPal plus add 3 percent ..Otherwise Postal or International money orders only
Thank You .. Marconi *^_^* and The_kcar
Sorry HS-1 Optic Table Mount (shown in the pictures) is NOT included