Well, I have the bug. I got into lasers a while back and have purchased a couple cheapo Chinese RGV systems, have played and now am an addict. I have used them to learn the Pangolin software and now I want to build a proper laser projector and get it varianced for my own personal use. I have looked over all the paperwork and requirements and have a basic understanding of the complexity involved. I'm sure I will have far greater questions around the corner. I know this is going to be a long process and I'm in no hurry, so I have no reservations in doing a build.
I'm looking to start simple and do a single 1 - 2 Watt 532nm analog diode and power driver setup. In the future, I may add more colors, but for now I just want to keep it simple to learn.
My first question is where do I look for the laser module and what do I look for and what do I avoid. I want to make sure that I get what I'm paying for and not some over-exaggerated junk that will cost me more in the long run. I have looked at some stuff from AIXIZ and I'm noticing a wide variation in price on modules with the same power output. I have also looked at the Chinese stuff on ebay and I wonder if any of it is any good and if so what suppliers should I deal with.
I want to specifically know if there are any options on the power supply that I should look for to make getting the projector varianced easier.
All your input will be much appreciated. If anyone is located anywhere near my location of Somerset, KY that would be willing to allow me to meet them and share some info with me in person, it would also be greatly appreciated.
Cheers, Ian