Results 1 to 2 of 2

Thread: would this driver work?

  1. #1
    Join Date
    Nov 2009
    Location
    Sliedrecht, Netherlands
    Posts
    332

    Default would this driver work?

    just found this:
    http://www.roithner-laser.com/datash.../EU-38-TTL.pdf

    would it be ok to run with a 1W 445nm?

    if not any other driver in here that would be ok?
    http://www.roithner-laser.com/ld_drivers.html

  2. #2
    Join Date
    Sep 2006
    Location
    Netherlands
    Posts
    1,435

    Default

    It will work, but only ttl (on/off).
    And it is doubtful if you will reach 1A.
    Supply voltage is 5V, voltage of a 445 diode @ 1A is around 4,5 volt.
    That leaves 0,5 volts for the driver, which is probably too low.

    So you'll need a driver that has a supply voltage of at least 6 volts, capable of at least 1 Amp, at least 10kHz preferably analogue modulation.

    Why not use the die4drive or the flexmod ?
    Or do you insist on spending m€ga on a driver?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •