Program board inline adjustments?

[neutrino]

Hi all,

So I have just received 2 sets of SCANLSP20K scanners or two 445 flank scanners. I also have the program board with these. My ILDA control cables are enroute with a shipping company.

In the mean time I want to obviously use them. I will run with sound mode. Is there a way to put some pots in line to allow me to adjust the max brightness? and also to adjust the max size, x and y?

On a slightly different note. These will remain single color blue projectors. Should I connect the laser to the blue output or intensity? My center projector will be RGB.

Thanks all

Cheers
Rich

[polishedball]

this I believe would be the same advice for size control.

http://www.photonlexicon.com/forums/...highlight=adat

[-bart-]

The intensity-output of most DACs are ttl.
Using these you'll have no fading effects.

Using the blue output will get you only the blue components of your show.

If you want all rgb-components in to your blues AND analogue output, you'll need a second dac OR a summing amplifier.

Audrey ran into similar isues