Results 1 to 4 of 4

Thread: Suitable TECīs?

  1. #1
    Join Date
    Jun 2008
    Location
    Stockholm, sweden
    Posts
    352

    Default Suitable TECīs?

    Hello ppl.. working on my own builded Quad module and need some advice on TECīs.

    i bought some cheap TECīs from ebay a few weeks back.
    91.2W 12Volt 6A 4x4cnm

    They are ok but they get very hot on the heat side and my baseplate inside my module is not enough to spread out the heat and after 5minutes the heat goes up to the cold side and after 15min there both hot.

    so i think i might need some smaller TECīs with different data.,

    any suggestions what and where i can buy some at nice price.?

    thnx.

  2. #2
    Join Date
    Dec 2008
    Location
    veenwouden
    Posts
    2,538

    Default

    Roitner has some nice ones.

    http://www.roithner-laser.com/pricelist.pdf

    I like the 30x30 with a hole in it and not very expencive

    By the way your mounts and baseplate are shipped

  3. #3
    Join Date
    Jun 2008
    Location
    Stockholm, sweden
    Posts
    352

    Default

    very nice.. thank you.


  4. #4
    Join Date
    Dec 2008
    Location
    veenwouden
    Posts
    2,538

    Default

    good service comes in many ways

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •