LD2000 - Zones problem

[Phredy1]

Somehow awhile ago I was trying to get LivePro to project into a small area. If I remember correctly, there was some setting in Showtime / Zones to output zones 2-4 into zone 1. That way I had all my beams going where I wanted them. Worked good....then.

Now when I go to play one of the pre-made shows the graphics / beams are all mucked up. They used to play perfect before I screwed up. I have looked everywhere trying to find how to put things back like they were before and no luck. I can't even find how I made the changes the first time. My CRS is getting worse I think.

I have replaced the LD2000.ini file with an original I had backed up and even that didn't work. Anyone have an idea of wtf I did and how to fix it? I suppose I could delete everything and start over, but except for the zones I have everything how I like it.

-Gene

[allthatwhichis]

Most "beams" are in zone 3 which should project a test atter at 100% of your scanner's angle, or it seems that way. I would verify what zone those beam frames are set up for and use the projections zone geometric correction controls to get the beams where you think they should go.

[Phredy1]

Never mind, I got it fixed. Uninstall / Reinstall was the easiest fix.

Note to self: Don't mess with stuff I'm not sure about....