WTB Olike SK20 clamps

[polishedball]

Looking for 2 to 4 of these mounts if you have any for sale please PM or respond here. Thanks If you just have a single for sale would buy it also doesn;t need to be a pair.

photo lifted from SPec hope ya don;t mind.

[Admin]

I'm currently working on another source that might be the manufacturer instead of someone pretending to be the manufacturer... Gimme a couple of days to figure it all out.

I also need to order more of those ss/ptfe split rings.

[hobbybob]

Not to burst anyones bubble or business, but i have been researching the possibility to build my own CNC machine this spring and found that these SK20 clamps are used to hold the linear ball bearing rails for CNC machines.

You can get these also in SK12 (heeee... 12mm hole, can hold aixiz!)

I have seen prices as low as USD $15.95 for a set of 4 !

Just a tip from Hobbybob ;-)

[polishedball]

Not to burst anyones bubble or business, but i have been researching the possibility to build my own CNC machine this spring and found that these SK20 clamps are used to hold the linear ball bearing rails for CNC machines.

You can get these also in SK12 (heeee... 12mm hole, can hold aixiz!)

I have seen prices as low as USD $15.95 for a set of 4 !

Just a tip from Hobbybob ;-)

Have you a link to purchase them?

[hobbybob]

Yes ofcourse, here it is:

http://rover.ebay.com/rover/0/e11030...EF%3AUS%3A1123

There is SK12, SK20 etc... only 13 dollars !

[Ubersapian]

I'm currently working on another source that might be the manufacturer instead of someone pretending to be the manufacturer... Gimme a couple of days to figure it all out.

I also need to order more of those ss/ptfe split rings.

Where can one buy those ss/ptfe split rings from ?