What a hell of a nice module Dave. I'm tempted to buy two pieces now, to replace the inadapted ones I planned to use first
Last edited by dave; 11-05-2010 at 06:47.
KVANT Australian projector sales
https://www.facebook.com/kvantaus/
Lasershowparts- Laser Parts at great prices
https://www.facebook.com/lasershowparts/
Arg that's really nice engineering!! All is adjustable, I like
Just to be sure, it's going to be a knife edge combining? So is the mount for the mirror also adjustable, like a micro mirror mount?
It is adjustable, Ill shoot you a PM explaining how to adjust it- Its a little more difficult to adjust, but once you have it locked in position, it is not going anywhere.
KVANT Australian projector sales
https://www.facebook.com/kvantaus/
Lasershowparts- Laser Parts at great prices
https://www.facebook.com/lasershowparts/
Last pic. Assembles very easily. Last screws will be with me tomorrow, so I can send bits on Tuesday
KVANT Australian projector sales
https://www.facebook.com/kvantaus/
Lasershowparts- Laser Parts at great prices
https://www.facebook.com/lasershowparts/
Would it be possible to add a 40x40mm TEC under the plate which holds the diode's mounts? Or would the height be too high...
Its designed for a TEC, if no TEC is used, then you will need to use a aluminium spacer that is 4mm in height. Or a 4mm high TEC
I thought this TEC looked nice - digikey part number 102-1677-ND. Its a 30w TEC, 8.6V 6A
KVANT Australian projector sales
https://www.facebook.com/kvantaus/
Lasershowparts- Laser Parts at great prices
https://www.facebook.com/lasershowparts/
Nice I just have two 40x40x4mm TEC sitting on my desk...
I cannot wait to receive mine!! Thanks Dave (and Simon )
Out of interest, how hot do you think these can run without a TEC? Would 700mW per diode be ok do you think?