CNI 532nm 1,35W DPSS Laser 2pcs

[Tonix]

Hello!
I have a 2 pcs New CNI DPSS Green laser module 1W (523nm).

Testing reports:

Wavelength (nm): 532±1
Output power (mW): >1000 mW
Transverse mode: Near TEM00
Operating mode: CW
Power stability (rms, over 4 hours): <1%, <3%, <5%, <10%
Warm-up time (minutes): <10
M2 factor: <2. 0
Beam divergence, full angle (mrad) : <2. 0
Beam diameter at the aperture (mm): ~3. 0
Beam height from base plate (mm): 29
Polarization ratio: >100:1
Pointing stability after warm-up (mrad): <0.05
Operating temperature (℃): 10~35
Analog modulation
Expected lifetime (hours): 10000


For the price I ask 1250USD or 1000 euro by 1 pcs. + shipping from Ukraine.



Greets,
Anton

[ElektroFreak]

Due to the fact that CNI doesn't offer lasers rated at "1350mW", I'm curious what these heads are rated as being?

[AudioVisualizers]

EF: It says the rated power on the sticker on the PS in the upper right-hand corner of the first pic. 1 Watt.

[ElektroFreak]

got it.. thanks. I guess it would help to look at the pics up close.. I think these should be listed as what they are then.. the extra bonus doesn't count. The power rating is an end-of-life rating, which is what matters. These will not make 1350mW over their whole lives..

jus' sayin'

[Tonix]

Due to the fact that CNI doesn't offer lasers rated at "1350mW", I'm curious what these heads are rated as being?

sure CNI name is 1W. real power is 1,35W. you can see it at the Test report:

http://www.photonlexicon.com/forums/...chmentid=19718

[RGbee]

sure CNI name is 1W. real power is 1,35W. you can see it at the Test report:

http://www.photonlexicon.com/forums/...chmentid=19718

No offense, but that's like me saying i have a 12" penis and 2lb balls, when in fact they may only be 0.5lb's. Is there any way you can have it independently checked through a calibated meter

[Tonix]

i correct the post.

[Tonix]

New price: 1250 usd or 1000 euro by pcs.

[DjHeadie]

No offense, but that's like me saying i have a 12" penis and 2lb balls, when in fact they may only be 0.5lb's. Is there any way you can have it independently checked through a calibated meter

i think that is unfair to ask unless you are ready to put those balls on a calibrated scale, as even hitting 8oz could be tough....

also, thanks for the lols

[RGbee]

i think that is unfair to ask unless you are ready to put those balls on a calibrated scale, as even hitting 8oz could be tough....

also, thanks for the lols

Hand me the scales