Results 1 to 1 of 1

Thread: Image size/shape

  1. #1
    Join Date
    Aug 2010
    Location
    Michigan
    Posts
    69

    Default Image size/shape

    Hi,

    I just got done moving everything into a new case and when the scanner was sitting on the table, the image was great. Now that I have it in the case, the image is extremely narrow and I can't figure out whats causing it.

    I've tried adjusting the image in QS but even at 100% width, it's still a little on the narrow side. I can go through my wiring again but I just went through it twice when I wasn't getting any output at all but that was due to a stupid error. I have a male db25 breakout board and I plug it straight into the FB3 and I "missed" the first time and had the bottom row of pins in the top holes.

    Any idea what could be causing the strange image or what to check?

    EDIT: It was a bad ground connection on the x galvo input so all is well.
    Last edited by Howie; 10-17-2010 at 18:13. Reason: Figured it out

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •