Image size/shape

[Howie]

Hi,

I just got done moving everything into a new case and when the scanner was sitting on the table, the image was great. Now that I have it in the case, the image is extremely narrow and I can't figure out whats causing it.

I've tried adjusting the image in QS but even at 100% width, it's still a little on the narrow side. I can go through my wiring again but I just went through it twice when I wasn't getting any output at all but that was due to a stupid error. I have a male db25 breakout board and I plug it straight into the FB3 and I "missed" the first time and had the bottom row of pins in the top holes.

Any idea what could be causing the strange image or what to check?

EDIT: It was a bad ground connection on the x galvo input so all is well.