Hi all,
I am using LD2000 and 3 projectors: 1x RGB and 2x 1W Green
I want to use the fourth color channel for the greens.
A trick McCarrot taught me.
He uses it in Livepro, trains the colorpallette for High Power to have the fourth color channel open on all colors and then the greens go along with every color.
A sort of intensity but then in software.
I want to use this trick with Autoplay, does this work ?
I can't seem to get it at work, i go in palette training, do Simple training.
Slide the 4th, 5th and 6th channel open in alle profiles on all colors.
I expected that that would give me full power green whenever a color is on.
It said training the colorpalette, then percentage counter went up for all 3 palette, then asked to use it ? i press ok. Played a show in Autoplay, no output on 4th channel.
But it don't work, if i connect the modulation wire of the laser on R, G or B i have signal, when i connect to 4th channel no way jose!
Does Autoplay use the pallette you create ?
Do i forget something ?
Any help is appreciated. At least i am quite happy i got all 3 projectors working.
I swapped out the cheap Ilda board which was not working correctly with differential.
Put in another one of Rob's boards (i am getting quite used to this hahaha) and worked much better, much more power.... so i am happy. Now i need the greens to work whenever there is color displayed (like an intensity channel).
On the other projector i made a small pcb using 6 diodes (BAT85) and works like a charm, but would be cool if i could learn the Palette trick as well.
Hope someone understands my vague story and has advice, show is to be played fridayevening, built up tomorrow morning/early afternoon.
Will get the diodes as a backup ;-)