I have here a Dell GX1p based data acquisition system that would be perfect for a home lab/analysis setup.

It is a labview based system which includes labview.
Contains 3 acquisition/control cards:

Microstar Dap 3400a 3.2 Megasamples/sec data acquisition processor with onboard computer, 16 channels
National instruments PC-TIO-10 digital timing I/O board
National Instruments AT-MIO-16x Programmable gain 16 bit data acquisition, analog input, analog output card with DIO. 16 single ended/8 differential analog input channels, 2 16 bit analog output channels


The computer is a P3 500MHz with (I beleive) 768MB ram, with the above cards installed it will have 1 ISA slot free and a few PCI slots free.

The two national instruments boards take regular ribbon cable connectors and the Microstar takes a different connector that I also can supply.

I will include all the software and manuals I have, including the microstar labview interface modules but you will have to set up and install it.

Please make an offer!