Dilemma

[neutrino]

Hi All,

So I have a dilemma to try and figure out regarding my projectors.

I'm deciding what to do with my Lasever 200mW 473nm.
I am in the process of building a projector with the following specs:

LW 500mW 532nm
Andy_Con 1.2W 650nm
Self built 1W 445nm
DT25 scanners
FB3

So I was thinking of adding the Lasever into this setup. However it is only putting out 180mW give or take so may not have much of an impact.
I also have another set of scanners kicking around plus a 200mW 532nm module and 500mW of 650nm. So I could build a second RGB if I didn't use the 473nm in the big projector.

What do you guys reckon. Throw everything into one large projector. Or go with two but with slightly different color palettes.

Any ideas/suggestions.

Cheers
Rich

[andy_con]

has the module arrived yet?

[neutrino]

Hi Andy,

The module has arrived at my friends address in the US. It missed me by a few days. I am now back in Honduras so will have to figure out getting it forwarded to me down here.

Can't wait to get my hands on it. I trying to get the green and blue components added to the projector so I only need to drop in the red module. You gave me the dimensions in a PM so it should be fairly straight forward.

Cheers
Rich

[andy_con]

look forward to seeing it being used

[neutrino]

me too!!!

What do you reckon on the situation with the blue? Build one projector or shuffle parts and build a 2nd?