ML10 RGB Retro

[wondertwnz]

I am working on a ML10 I have. Putting a 1W DHOM from Marc and 2W of Blue Knife edge with the O-Like Lens and a RGBSytems 200mW/ 632nm Red I had setting around. Mounted it all on a 12" x 8.5" x1" Heat sink (Mostly for the Blue). took off the original Color flags and used those signals via DMX to control the Modulation on each color.
Put a Solid state relay controlled by the interlock to supply power to all of the modules so they have no power without interlock.
Had to drill out the holes for the turrets and I increased the size on the initial bounce mirror to accommodate the blue mostly

Still working on mounting the Shutter back up and a cover for the Lasers but so far looking great.

If all goes well I plan to do the other ML10 I own as well.

Larry

[flecom]

very nice!!

how do you plan on enclosing the whole thing??

[wondertwnz]

very nice!!

how do you plan on enclosing the whole thing??

That is the million dollar question.
I made it so all of the edges of the heat sink are accessible, Hoping to just build a cap of sorts and drill and tap the sides of the heat sink to attach. Just some simple angle and flat pieces all riveted together I think