SCANLSP30 drill pattern

[polishedball]

Does anyone have a copy of the drill pattern for a SCANLSP30 galvo block. I want to build a new table for one, but it is currently in service and not accessible until the new project is done.

Thanks

[p1t8ull]

As if looking at the base of the block -

[polishedball]

As if looking at the base of the block -

Thanks, to be clear the laser would enter from the right side of the "front"?

[p1t8ull]

Thanks, to be clear the laser would enter from the right side of the "front"?

Sorry, wasn't too clear there

Changed it so looking down on your baseplate this is where you would drill the holes, assuming the same beam path

[polishedball]

Sorry, wasn't too clear there

Changed it so looking down on your baseplate this is where you would drill the holes, assuming the same beam path

Thanks you very much!