1/2 wave plates are ready to go

**dave** · 01-09-2011, 02:53

OK, Time to get this in effect. Ill start sending some Private messages tomorrow

**Beaves** · 01-09-2011, 07:18

Hi Dave,

I would take

3 at 445nm 25mm mount
2 at 660nm 25mm mount
1 at 640nm 25mm mount

Thanks

**csmn** · 01-09-2011, 10:02

Hi Dave,

I go for 10x 445nm, no mount

**dave** · 01-10-2011, 02:36

Everyone should have a private message. Let me know if I missed anyone.

**Jem** · 01-10-2011, 02:45

Thanks Dave

Payment sent

Jem

**dnar** · 01-10-2011, 04:48

Dave, you missed me, 1 x 660 with mount please.

**Roy G. Biv** · 01-10-2011, 05:18

Dave,

I´d like to jump in on two 445 nm waveplates with 25 mm mounts, if it is not too late.

**wells** · 01-10-2011, 10:36

Hi Dave, all,

I'm new here, saw a note in holoforum where I've been reading up on archives and lurking a bit... I've acquired a used C-315m, and plan on doing some holography (other than my stunning multimode-red-diode integraf-kit work, Mmmm, stripey and dim)

I would love three 532mm waveplates, in 25mm mounts, if they are still available. Thanks in advance,

Wells

**RedlumX** · 01-10-2011, 12:58

Uh oh now that I have paid, I just wanted to have it confirmed that the plates are AR coated both sides, right? I had asked before but I cant see an answer...

Best,
Wolfgang

**dave** · 01-10-2011, 14:42

I asked the manufacturer the question, and yes, both sides are coated

I thought I wrote it above some where

Originally Posted by RedlumX

Uh oh now that I have paid, I just wanted to have it confirmed that the plates are AR coated both sides, right? I had asked before but I cant see an answer...

Best,
Wolfgang

Thread: 1/2 wave plates are ready to go

Thread Tools

waveplates, new member

Posting Permissions