Hello guys
I,m about to start with using my brass blocks to build a quad setup with telescope. I have two diffent type of lenses that i can use for collimating the diodes. The brass block will be mounted on a Tec. I can,t isolate the diodes from eachother so i want to run them parallel like DNar his quad. I think he uses a 1 ohm resistor to run them parallel. I have some Lasever drivers to use to power this setup but its a Negative side driver but i have also a flexmodP3 availaible.
Could someone give me some info on the resistor that i need to run them parallel and also if my setup is mounted on a Tec plate and so its isolated from the baseplate can i use my lasever driver for it?
Thanks guys i hope you can help me with this.