Unbalanced signal to balanced input scanners

[polishedball]

Can you feed a normal scanner set an unbalanced signal?> I have not been able to locate my GS120's that I put in a very special place. So I am curious if I can use just a regular scanner set and drivers?

Thanks

[Doc]

You will just need to ground one terminal of each scanner amp to pin 25

[mixedgas]

It might shock you to know that ILDA once published "preferred" circuits as the part of the standard.

This is the preferred ILDA driver for single ended to DIFF, redrawn from the 1985 version of the standard, which came as almost 90 pages in a nifty three ring binder.

Steve

[polishedball]

It might shock you to know that ILDA once published "preferred" circuits as the part of the standard.

This is the preferred ILDA driver for single ended to DIFF, redrawn from the 1985 version of the standard, which came as almost 90 pages in a nifty three ring binder.

Steve

Thank you Steve!

[polishedball]

You will just need to ground one terminal of each scanner amp to pin 25

Pin 25 might be hard to find on this

http://www.photonlexicon.com/forums/...dreams-rebuild


thanks though will try it the dirty way as you suggested, then i'll dig out some opamps like Steve posted.