Looking good, and providing the incentivising 'mental boner' I need to get on with mine![]()
Looking good, and providing the incentivising 'mental boner' I need to get on with mine![]()
A little bit werrrr, a little bit weyyyyyy, a little bit arrrrgggghhh
nice beams andy
should have my sextuple 640 finished next week too
When God said “Let there be light” he surely must have meant perfectly coherent light.
I think this is the route I'm going to need to go for my red, s long as I can make it fit in the space.
Out of interest, what is the approximate component cost to put one of these together, assuming using Dave's mounts?
look forward to seeing it at the meetnice beams andy
should have my sextuple 640 finished next week too
Eat Sleep Lase Repeat
When you temp tested what was the temp differential you could achieve before things went too far "out of whack"? Also, did you notice hysteresis? Hysteresis seems to be the plague of combiners.
Ok, say you align your mounts at 25deg C then raise the temp of the whole combiner to 50dec C. Clearly, at 50deg C the beams are going to be way off. After the temp goes back to 25deg do all the beams return to the same exact position. If not, the difference is the hysteresis. I have found this to be the hardest thing to fix. Doesn't seem like a big deal but, If the combiner is taken out in the cold or put in a hot car it then has to be re-aligned.
Are the roithner 7020h lenses the same as the aixiz plastic? They look exactly the same in the pictures I have seen.
from 25 degrees to 50 degrees... im guessing thats just an example as thats a massive difference.
when put on a heat sink the temp of the modules raises by a few degrees.
the mirror mounts dont move, the metal lens housings dont move. but i think whats happening is the actual plastic lens changes shape as it heats up and cools down. so yes the beams go back in perfect alignment, well they have so far.
Eat Sleep Lase Repeat