I expected this coming ^^
it was a great LEm and everyone was not very but EXTREMLY helpful to me
but now i do need some help finishing up this projector.
for example the PT-ITRUST board, wich is connected to the galvo's...it has a slot for the cable that (according to the manual) is for power in.
i have the cable, but cant find where that cable should go.
Here is the manual of both the PT-30K and PT-ITRUST:
http://www.phenixtechnology.com/en/down.asp
And here are some images:
http://gdteam.net/images/lasers/proj...hing/index.php
photo 1 shows the galvo PSU...and 2 letters "L & N" and a mark. i did not get the cables to connect to those parts...but i have alot cables left from the old galvos.
If i strip them until copper is left, connect them beneath those screws....then where should those cables go to?
photo 2 shows the galvo drivers...with both 2 cable slots left wich says "power out" according to the manual. again, i have the cables....but where should they go to?
photo 3 also shows 1 cable slot left....the power in, according to the manual.
I have the cable, but where should it go to?
photo 4 shows the complete projector as it is now.
If any photos or video's are required, do tell me. i will gladly make them because i really need the help.
Thanks!