both red diodes are probably near death.
you can replace them with 445 diodes, but..
1) you will need a different set of dichros
2) you will need a different set of drivers
3) if your projector was compliant (kind of doubtful since it was laserworld), it may no longer be due to changes in the wavelength and output power.
c.
Originally Posted by
LaserWolf
Steve-
You are right, after further investigation, I found that the Red diodes were rated at '150mw'.
My question... Can I replace these diodes with M-140 445nm Diodes?
Also, from the look of it, BOTH of the red diodes are very weak. Do you think they are BOTH 'out' or do you think they are BOTH having a signal/power issue?
I looked on the side of the DPSS green laser. It says '700mw'... Since it is laserworld.. I would assume it is about 200mw. It's very bright and tight though!
Ultimately, i would love to add about 3-4watts of 445nm blue to this projector... can anybody help a brother out??
suppose you're thinkin' about a plate o' shrimp. Suddenly someone'll say, like, plate, or shrimp, or plate o' shrimp out of the blue, no explanation. No point in lookin' for one, either. It's all part of a cosmic unconciousness.