Some scanner problem.
I bought a Terrascan kit about a month before Christmas and now I hooked it up to my new Easylase unit. Now I have a problem with it. Everything looked like it was working fine then one channel started to act up and I had some sort of interference on that channel even when I had no output. I measured all input to the terrascan and everything looks OK. The signal is stable and so are the power at +-23 volts. Not even with the oscilloscope at maximum zoom I could pick up much interference or instability. I tried to output ILDA test pattern and I looked OK except for the interference. Then it happened. One channel dies and short after the other goes out. I double cheked the power and signal but everything looked fine.
Any ideas on what could have gone wrong here?
You know, I have one simple request. And that is to have sharks with frickin' laser beams attached to their heads!